What's going on at The Aero Garage (Vendor Introduction and Updates)

[Tdeman]

Bueller, anybody......

I know you've heard it before, but I'm working on replenishing Ti Down kits.

Why's it taking so long?
Around New Years the machine I use to produce these was converted and setup for automated, large volume production run of a single part for an OEM, which has kept the spindle turning about 20 hours a day. This physical machine setup is unfortunately not conducive to throwing in small batches of alternate parts.

The good news is that this machine setup is evolving, and I'll soon have table space on the machine to roll in a batch of Ti Downs and Jack cups. With that in mind, I have a LARGE amount of stock showing up this week so I can get these restocked, in bulk.

I'm still not going to take pre or backorders on these, but you can expect to see these in stock and ready to ship before the end of the month.

Thanks everyone.

 

[rvjl]

I know you've heard it before, but I'm working on replenishing Ti Down kits.

Why's it taking so long?
Around New Years the machine I use to produce these was converted and setup for automated, large volume production run of a single part for an OEM, which has kept the spindle turning about 20 hours a day. This physical machine setup is unfortunately not conducive to throwing in small batches of alternate parts.

The good news is that this machine setup is evolving, and I'll soon have table space on the machine to roll in a batch of Ti Downs and Jack cups. With that in mind, I have a LARGE amount of stock showing up this week so I can get these restocked, in bulk.

I'm still not going to take pre or backorders on these, but you can expect to see these in stock and ready to ship before the end of the month.

Thanks everyone.

Hi Taylor,

Any update on when you might have more of these in stock?

Cheers

 

[WWhunter]

X2

 

[MacCool]

X3

 

[Tdeman]

Hi Taylor,

Any update on when you might have more of these in stock?

Cheers

X2

X3

Yes! They are in hand and being boxed.

They'll be back in the store tomorrow.

I have a new size of jack cup (1.15" 1.05" bore) as well to better fit the jacks with smaller rams. I've found many of the 3 ton jacks have a reduced diameter for the last ~1" of ram.

 

[Tdeman]

Correction: New Standard size is 1.05", not 1.15"

All sizes are back in stock.

Get 'em while they're hot!