What's new
Van's Air Force

The definitive Van's Aircraft support community! Buying, building or flying an RV? Join our exclusive family of mentors and enthusiasts!

Trim indicator Dynon Skyview

D

davesplace

Member
Unable to see trim indication on skyview, how to calibrate, not seen in Hardware calibration, EMS calibration...on set up. Any suggestions.\:confused:
 
Calibration instructions are in the Dynon manual. The indicator will not appear until the calibration is complete.
 
First you need to ensure that you have mapped the trim sensor potentiometer to an available general purpose input. Additonally you need to supply +5 volts through the trim potentiometer instead of +12 volts. There is a +5 volt pin on the EMS 37 pin harness pin # 18 which is also used for a MAP indicator. You should then be able to perform the trim calibration. After calibration if the trim indicator is not displayed on your Skyview you will need to go to the screen layout editor and add it.
 
You must log in or register to reply here.
Back
Top