I am trying to track down a slight shimmy when I land and apply the brakes. I have gone through the mains, warped rotors, wheel bearings, tire roundness, it all checks good so I am focusing on the nose wheel.
I have rechecked the break-away torque but notice the castle nut moves within the cotter key when the fork is moved side to side. I don’t recall noticing this before and would think it would eventually wear the threads.
The shimmy started shortly after the new nose leg and fork was installed.
Advice?
I have rechecked the break-away torque but notice the castle nut moves within the cotter key when the fork is moved side to side. I don’t recall noticing this before and would think it would eventually wear the threads.
The shimmy started shortly after the new nose leg and fork was installed.
Advice?