Is there any better drawings than C2 about how to install the Cleveland brakes?
My question is on the right brake, I will need to move the zirk fitting from the top to the bottom so I can put the blue 90 degree fitting to connect to my brake hose. When I try to take the zirk fitting out, it is very tight - to the point I am afraid I will damage it trying to remove it. That gives me cause to believe it is tight for a reason.
Am I missing a drawing or better instructions? Maybe I need to heat it a bit to loosen? Thanks
My question is on the right brake, I will need to move the zirk fitting from the top to the bottom so I can put the blue 90 degree fitting to connect to my brake hose. When I try to take the zirk fitting out, it is very tight - to the point I am afraid I will damage it trying to remove it. That gives me cause to believe it is tight for a reason.
Am I missing a drawing or better instructions? Maybe I need to heat it a bit to loosen? Thanks
Last edited: