When reading the left side of figures 3 & 4, is there an assumption that the part is sitting flat with the angled portion of the part extending toward you? I can't see any cues on the drawing that makes that certain, but I'm no engineer, I don't know if this is always an assumption or something.
You could also be looking at the part from the flat side with the angle extending away from you, which in this case, would matter since the part isn't symmetrical.
I'm just curious if I'm missing something, whether it is on the drawing, or a convention I'm not aware of.
You could also be looking at the part from the flat side with the angle extending away from you, which in this case, would matter since the part isn't symmetrical.
I'm just curious if I'm missing something, whether it is on the drawing, or a convention I'm not aware of.