RVG8tor
Well Known Member
I need a restrictor fitting for the manifold pressure line, only 2 supplied with the FWF kit (one each for Oil and Fuel) Van's sells them for $19.50 (VA128) but I read how some guys make them on this forum. I don't own a #60 bit the closest I can some up with is 1/16". So is there anything magical about the .040 hole in the restrictor Van's sells.
The restrictor is there to prevent a catastrophic leak of air if one of the lines connected to it break, so a 1/16" hole would allow a slightly bigger leak over a .040 hole but should serve the same purpose yes?
I have the fitting threaded and will JB weld the bolt into the fitting then cut off the end.
Cheers
The restrictor is there to prevent a catastrophic leak of air if one of the lines connected to it break, so a 1/16" hole would allow a slightly bigger leak over a .040 hole but should serve the same purpose yes?
I have the fitting threaded and will JB weld the bolt into the fitting then cut off the end.
Cheers