Ken Patton
Member
I’m not sure if this has been discussed before but I have found an easy way for me to move washers into very tight narrow spots. I use a long thin piece of (waxed dental floss) and run it through the washer and suspend it in front of the hole Inline with the bolt that will be going on. Once the shaft is completely through the washer, simply let go of one end of the dental floss and it should pull out without much resistance .You may have to use a thin piece of metal to move the washer around into the exact spot but it will remain suspended there until the bolt goes through. This works with multiple washers at one time also. Anyway I’m sure this has been discussed before but I have yet to see it and if not I hope it helps relieve some frustration.