The Skyview HDX in my RV-12 is showing a red "X" over the fuel pressure indicator. I have checked all the connections and they all seem sound. As a result, I am planning to buy a new fuel pressure transducer. I have been on the Van's site, the Lockwood site, and the Rotax site, but cannot figure out what part number I need to buy. Any guidance would be appreciated. Thanks.
Van's Air Force
The definitive Van's Aircraft support community! Buying, building or flying an RV? Join our exclusive family of mentors and enthusiasts!
Fuel Pressure Transducer
- Thread starter N87TB
- Start date
Have you checked Dynon to see what they provide? I recall a SB on some transducers that were leaking under pressure so a different one was being offered. The carburetor equipped Rotax 912 of course used the lower pressure maybe 0-15psi. You might be better off calling Lockwood because I would be surprised if they didn’t have the correct transducer. I recently watched a webinar by Brett Lawton from Advanced Powerplant Solutions, and he offered technical & product support for Rotax, 800-532-4362. Also BuyRotaxParts.com was from this same group.
Dynon Skyview Fuel / Fluid Pressure Sender Kavlico V2 1/8-27 NPT 15 PSI Mfg. #103755-000 available from Aircraft Spruce. Here's the link - https://www.aircraftspruce.com/cata...YakSXoxouLnGOtlThXLWqQUfGzulEYgUaAsTTEALw_wcB
Thank you for the referral for Brett Lawton.
Thank you. I have ordered the part.
Before you buy a new transducer give me a call at SteinAir. I'd like to help you make sure that it is needed! If this is a new installation I would be surprised if it is a bad sensor right out of the box.
Frankmali17
Member
When you order that 15psi sensor from Aircraft Spruce, does it come with the recommended resistor for dynon installation?
