F-7106 Fwd Top Skin - riveting aft three rivets to side skin/longeron

[jimzap]

How did you get a bucking bar on back of these rivets?

Due to the canopy deck, there is a thin gap to get the bucking bar in there.

Modify a bucking bar?
Thx

 

[wirejock]

I have a thin tungsten. If memory serves, that's what I used. Same on the 7.

 

[BillL]

Easy peasy with it all apart like that and must be done now!! Use a bucking bar with an offset foot.

I had to remove the roll bar attachments then put them back in - - 25hrs. eeek!!

1-3/4 Lb. Bucking Bar | Aircraft Spruce

1-3/4 Lb. Bucking Bar Bucking bars are cast with ductile iron to insure non-porous finish which is very important in order to have a highly polished finished surface. They are heat treated to 38-42 RC and therefore can be repolished many ti

www.aircraftspruce.com

 

[Stoo]

I used cherry structural blind rivets in that area on the 6.
Stewart Willoughby, 6

 

[PaulvS]

How did you get a bucking bar on back of these rivets?
View attachment 69611
Due to the canopy deck, there is a thin gap to get the bucking bar in there.
View attachment 69612
Modify a bucking bar?
Thx

I used an angled bucking bar, it is just a piece of structural steel that has been cut so that it will fit. It is the one on the top left in the picture.






.