I've been reading posts about valve guide reaming. It was interesting to note that some advocate not reaming the guide, but rather to just hone it using a 1/2" ball hone.
It makes sense to me that this would be a safer alternative, if indeed it does the job, and certainly a lot cheaper than the $150 McFarlane wants for their wiz-bang reamer.
My question is, which one to get? I see the Flex-Hone 1/2" ball reamer comes in 120, 180, 240, 320, and 800 grit. Any recommendations?
It makes sense to me that this would be a safer alternative, if indeed it does the job, and certainly a lot cheaper than the $150 McFarlane wants for their wiz-bang reamer.
My question is, which one to get? I see the Flex-Hone 1/2" ball reamer comes in 120, 180, 240, 320, and 800 grit. Any recommendations?