. . . . . .
My Garmin stack is so deep that I need to cut into the subpanel to allow clearance for this depth. The question is, do I make a hole that allows the panel mounted racks to just "float" in this hole or do I make the hole tight enough to help support the back of the rack in some way? I know I will need to add support to the edges of the cuts.
. . . . . . .
Bruce,
Thats the panel I intend to install myself,not that I have anything against glass, it's just that I want it to seem more like an airplane than a video game.
Outstanding! Very clean and uncluttered. Well done.
Did you fabricate the sub panel? Did you document the construction? Metal or fiberglass?
How did you do your placards; they look great.
Thanks! Made from .050" aluminum, primed, painted white JetFlex, then brown JetFlex, and finally sent up to Aircraft Engravers http://www.engravers.net. They engrave through the top layer of paint into the middle of the paint layer below. Not cheap but the work they do is really top notch.
![]()
Here's your pic Paul K...looking good
![]()
Do Over In Progress
![]()
Bill, how did you do the labels.....at least THEY seem to have worked OK.![]()
How did you handle the dual throttle quads?