When I installed the fittings for the reservoir brake lines I encountered that the brass insert did not fully bottoms against the end of the plastic tube.
No matter how hard I pushed (right after it has rested long enough in boiling water) it sticks out by .053".
I am unsure if that is ok, or if I will face a leaking problem later on because of that.
I may add, that I didn't drill the tube with a #29 bit as the instruction says in chapter #5. The instruction where the brake lines are made do not call for any enlarging the tube diameter.
Thank you very much for your opinion on that.
No matter how hard I pushed (right after it has rested long enough in boiling water) it sticks out by .053".
I am unsure if that is ok, or if I will face a leaking problem later on because of that.
I may add, that I didn't drill the tube with a #29 bit as the instruction says in chapter #5. The instruction where the brake lines are made do not call for any enlarging the tube diameter.
Thank you very much for your opinion on that.