Got around to trimming the F-1262 blocks per the plans and decided to do a test fit onto the W-1213 flap handle (after doing a little filing along the outside edge of the flap handle to remove some sharp edges). My blocks have to be worked onto the W-1213 flap handle ? it?s a very tight fit. I can hold the block in my hand and the flap handle won?t budge until I apply a fair amount of pressure to it.
Have others found these parts fitting this tightly? If so, did you sand out the hole in the F-1262 blocks or polish down the W-1213 flap handle or a combination thereof? Or accept the fact ? yep, it is a really really tight fit and move on?
Comments or suggestions appreciated.
Have others found these parts fitting this tightly? If so, did you sand out the hole in the F-1262 blocks or polish down the W-1213 flap handle or a combination thereof? Or accept the fact ? yep, it is a really really tight fit and move on?
Comments or suggestions appreciated.