jmjula
Well Known Member
I have my canopy frame hinged to the fuse and the side rails attached now. At some point I need to finish drilling the remaining skin to frame holes, but there is a large gap between the skin and frame on both sides for the upper row of rivets from front to back (the ones that were not pre-punched in the frame). I am pretty sure this is common, so how have others fixed this?
If I remove the lower clecos, I can get the skin to lay down nice, but then the lower holes are off by as much as 1/16" on the aft end. Adding spacers seems very difficult given the length and the taper required.
If I remove the lower clecos, I can get the skin to lay down nice, but then the lower holes are off by as much as 1/16" on the aft end. Adding spacers seems very difficult given the length and the taper required.