My first time priming today. S/W P60G2 at 1.75:1. Check out these speckles. Google says air pressure was too low to atomize. Can anyone else confirm?
Good thing it's a practice project. I *think* it got better after I upped the air pressure, but it's hard to tell over the existing speckles, and I didn't want to waste too much on the butcher paper cause I didn't mix much.
Good thing it's a practice project. I *think* it got better after I upped the air pressure, but it's hard to tell over the existing speckles, and I didn't want to waste too much on the butcher paper cause I didn't mix much.