Hallo. I bought a Catto propeller with associated hardware (Saber extension and crush plate) along with the precut spinner.
I installed the spinner but the front holes line do not match to the underlaying plate. Another way to explain: the front spacer is 3/32 thinner than necessary.
Would it be OK to place a few (3) AN960 washers between the front plate and the spacer in order to move forward the plate with attached nutplates? I believe this could be OK because propeller bolts will push on washers, then spacer plate and then spinner.
I hope I explained well my doubt.
Thanks.
Camillo
upload image on web
I installed the spinner but the front holes line do not match to the underlaying plate. Another way to explain: the front spacer is 3/32 thinner than necessary.
Would it be OK to place a few (3) AN960 washers between the front plate and the spacer in order to move forward the plate with attached nutplates? I believe this could be OK because propeller bolts will push on washers, then spacer plate and then spinner.
I hope I explained well my doubt.
Thanks.
Camillo
upload image on web
Last edited: