I'm about to start marking up my spar bars for cutting the optional taper, and just wanted to make sure I'm reading drawing 13 correctly as to the lengths of the various tapers.
If I'm correct, W606C has a total length of 109.5, with the taper starting from 91.5, 91.5 then being the length of W606D with its taper starting at 71.25, W606E length 71.25 with taper from 52.4375, W606F length 52.4375 taper from 35.875, W606G length 35.875 taper from 22.5.
So essentially at any point outboard of 22.5 only one bar is tapered at any point, with any other bars of that length or greater being full depth.
Hope that wasn't too laborious a description, pretty sure I have it right but wanted to check before cutting metal!
Thanks!
If I'm correct, W606C has a total length of 109.5, with the taper starting from 91.5, 91.5 then being the length of W606D with its taper starting at 71.25, W606E length 71.25 with taper from 52.4375, W606F length 52.4375 taper from 35.875, W606G length 35.875 taper from 22.5.
So essentially at any point outboard of 22.5 only one bar is tapered at any point, with any other bars of that length or greater being full depth.
Hope that wasn't too laborious a description, pretty sure I have it right but wanted to check before cutting metal!
Thanks!