High_Flyer
Well Known Member
Hello everyone,
Finishing wiring of my Skyview System on my RV-7 with:
2 Skyview Touch, AP module and VP-X, pitch and roll electric trim (Ray allen servos)
I'm connecting the Ray Allen servos to the Dynon EMS to have the auto-trim function.
Everything is connected, trim motors (pitch and roll) are working fine.
I have set up the Dynon and did the calibration to show trim positions.
The roll trim indication is fine, but the pitch trim indication doesn't work...
I initially did a temporary connection to check that things were working as expected and it did: trim running with trim buttons, and good trim position indication on the Skyview.
But after I finished the permanent connections the pitch indication isn't working anymore...
I re-checked all my connections and even re-did the wiring but I can't find anything wrong.
When I go in the Skyview Menu, EMS setup, sensor debug data I see that the values for pin 4 (pitch trim) don't change when I move the trim. The roll trim values are changing when I trim left or right.
I don"t know what to do next...
Any suggestions please.
Thanks,
Alain.
Finishing wiring of my Skyview System on my RV-7 with:
2 Skyview Touch, AP module and VP-X, pitch and roll electric trim (Ray allen servos)
I'm connecting the Ray Allen servos to the Dynon EMS to have the auto-trim function.
Everything is connected, trim motors (pitch and roll) are working fine.
I have set up the Dynon and did the calibration to show trim positions.
The roll trim indication is fine, but the pitch trim indication doesn't work...
I initially did a temporary connection to check that things were working as expected and it did: trim running with trim buttons, and good trim position indication on the Skyview.
But after I finished the permanent connections the pitch indication isn't working anymore...
I re-checked all my connections and even re-did the wiring but I can't find anything wrong.
When I go in the Skyview Menu, EMS setup, sensor debug data I see that the values for pin 4 (pitch trim) don't change when I move the trim. The roll trim values are changing when I trim left or right.
I don"t know what to do next...
Any suggestions please.
Thanks,
Alain.