tomkk
Well Known Member
I'm running SkyView 12 installed from Van's site. I have a pitch trim position indicator in the lower right corner of the EMS display but it's blank - no indication of trim position.
The trim motor operates correctly and I've checked the pins on both sides of the connector on the trim motor and they are correct. I've also checked continuity from the trim motor connector pin 3 (PTRIM SERVO POSITION) to the Control Module (WH-00046 pin 4). After that I get a bit lost in the schematics but I think the rest is purely between the Control Module, EMS Module and the D1000T.
I do not have an Autopilot Knob Module if that's relevant.
I don't see any setup that would affect this.
Am I missing something? What else can I check to shoot the problem?
The trim motor operates correctly and I've checked the pins on both sides of the connector on the trim motor and they are correct. I've also checked continuity from the trim motor connector pin 3 (PTRIM SERVO POSITION) to the Control Module (WH-00046 pin 4). After that I get a bit lost in the schematics but I think the rest is purely between the Control Module, EMS Module and the D1000T.
I do not have an Autopilot Knob Module if that's relevant.
I don't see any setup that would affect this.
Am I missing something? What else can I check to shoot the problem?