SeanB
Well Known Member
Installing the two shoulder harness steel cables from the tailcone. One side tightens to torque at the -4 bolt and is firm, and the clevis can still rotate with moderate force. The other side goes to torque and is still loose. I checked and believe I?ve run out of threads and am bottoming out on the grip of the bolt. Verified all hardware matches on both sides, so do not understand how this is possible.
Should these cables be allowed to move freely, or should they remain in fixed position?
My plan is to add another washer to each bolt. Leaves enough thread.
Thank you!
Should these cables be allowed to move freely, or should they remain in fixed position?
My plan is to add another washer to each bolt. Leaves enough thread.
Thank you!