I am building a 7a.
I fit the wings into the fuselage and used drift pins as the instructions call for. I did all the drilling required.
The problem is I can’t get the bottom drift pins out. The top ones were not too hard cause I could tap them out. The bottom ones are inaccessible to tap out because of the gear weldements. I’ve pulled, twisted, adjusted the wing heights to change torques, nada.
Im ready to remove the gear weldements with a cutoff tool and buy new ones just so I can maybe tap those bottom drift pins out.
Any ideas cause I’m REALLY frustrated.
I fit the wings into the fuselage and used drift pins as the instructions call for. I did all the drilling required.
The problem is I can’t get the bottom drift pins out. The top ones were not too hard cause I could tap them out. The bottom ones are inaccessible to tap out because of the gear weldements. I’ve pulled, twisted, adjusted the wing heights to change torques, nada.
Im ready to remove the gear weldements with a cutoff tool and buy new ones just so I can maybe tap those bottom drift pins out.
Any ideas cause I’m REALLY frustrated.