MacPara
Well Known Member
When browsing through section 33, Miscellanea, yesterday, I found a step on page 33-03 or -05 or -07 (not sure right now as I don't have access to the manual) that was asking for the holes of the aft most tunnel cover that go underneath the fuel tank to get dimpled with a #19 die for the flush head screws going in there.
I have the Avery tool kit and the only dimple die for screws I have is a #8 and that worked fine on all of them yet. When looking for a #19 dimple die I couldn't even find one. What did you guys use?
I have the Avery tool kit and the only dimple die for screws I have is a #8 and that worked fine on all of them yet. When looking for a #19 dimple die I couldn't even find one. What did you guys use?
