Hi,
I am building a RV14A (in the UK)
I am just a little confused with Section 48-04 Step 1 which instructs the builder to drill out 2 rivets. There appears no further instruction on what to do with the loose item FF00084.
I would think that the whole vent (heater) assembly needs to be air tight, otherwise there is a direct flow of air from the engine compartment to the cabin.
Any assistance would be most welcome.
Regards John
I am building a RV14A (in the UK)
I am just a little confused with Section 48-04 Step 1 which instructs the builder to drill out 2 rivets. There appears no further instruction on what to do with the loose item FF00084.
I would think that the whole vent (heater) assembly needs to be air tight, otherwise there is a direct flow of air from the engine compartment to the cabin.
Any assistance would be most welcome.
Regards John