Running through wiring etc and came upon a note on DWG64 referring to 12 off AN4-11A bolts that are fitted from the front of the forward face of the spar, through the web - these bolts are not fitted on the QB I have which is a 2010 produced kit.
As everything is together and as it says start building from page 42 - has
anyone else thought these should have been put in by Bonanza during assembly of the spar ?
They will be a challenge to fit and - where is the script to fit them ?
Also, 'found' two punched holes in the front spar web, not opened up, which are the routing for the rudder cables through the forward spar. As the floor
support is already riveted on, how is one supposed to open out to 5/8" and get a snap bushing behind the floor support......... ?
Re reading the rudder cable assembly, it merely says route from rear to front through the holes putting in snap bushings as you go. I assumed, incorrectly, that the rudder cables dove down and went through the spar at low level through existing carry through holes.
What is concerning me here is that the kit has evolved - Vans now get Bonanza to do lots of different work on the kit, however these changes are not encompassed in the build instructions.
I have reported this to Vans and will await a reply.
As everything is together and as it says start building from page 42 - has
anyone else thought these should have been put in by Bonanza during assembly of the spar ?
They will be a challenge to fit and - where is the script to fit them ?
Also, 'found' two punched holes in the front spar web, not opened up, which are the routing for the rudder cables through the forward spar. As the floor
support is already riveted on, how is one supposed to open out to 5/8" and get a snap bushing behind the floor support......... ?
Re reading the rudder cable assembly, it merely says route from rear to front through the holes putting in snap bushings as you go. I assumed, incorrectly, that the rudder cables dove down and went through the spar at low level through existing carry through holes.
What is concerning me here is that the kit has evolved - Vans now get Bonanza to do lots of different work on the kit, however these changes are not encompassed in the build instructions.
I have reported this to Vans and will await a reply.