Guy Prevost
Well Known Member
I'm starting to acquire instruments and look harder at panel layout. The pictures below are my currently intended layout. I'm not too flexible on components at this point, but would appreciate comments on layout and design.
The compass on the right is a Precision vertical card compass. What kind of interference issues can I expect? The blanks are for unknown upgrades. Space is reserved for a larger radio stack if I ever decide to upgrade to IFR.
Far left switch is boost pump, next 3 are landing/taxi/wigwag lights. Then strobe and position lights. Bottom right switches are mags and starter. Above that is DC master, top right is emergency bus.
The rectangle at upper right is the ELT.
Flaps, trim, ap disconnect and PTT are on the stick.
Ignore the red stuff on the right edge of the panel. I didn't realize that I had a part selected when I captured the screen shot.
Thanks!
Guy
The compass on the right is a Precision vertical card compass. What kind of interference issues can I expect? The blanks are for unknown upgrades. Space is reserved for a larger radio stack if I ever decide to upgrade to IFR.
Far left switch is boost pump, next 3 are landing/taxi/wigwag lights. Then strobe and position lights. Bottom right switches are mags and starter. Above that is DC master, top right is emergency bus.
The rectangle at upper right is the ELT.
Flaps, trim, ap disconnect and PTT are on the stick.
Ignore the red stuff on the right edge of the panel. I didn't realize that I had a part selected when I captured the screen shot.
Thanks!
Guy