Where did you start the cowl installation, Top first or Bottom first.
Vans suggests connecting the two halves at the front as step one. Problem with this ( if you check the picture where the halves connect, at the spinner end) the two halves are not parallel.
There are no trim lines moulded into the top half, as suggested by Van's. Without a reference point from which to make measurements a had to assume the top half was already cut to size.
You will also notice the huge difference cowl to spinner spacing between the top and bottom halves.
Not a very well written thread, still a little frustrated. If you can make sense of this thread then please explain your installation sequence
http://i44.tinypic.com/1kx3q.jpg
Regards Peter
Vans suggests connecting the two halves at the front as step one. Problem with this ( if you check the picture where the halves connect, at the spinner end) the two halves are not parallel.
There are no trim lines moulded into the top half, as suggested by Van's. Without a reference point from which to make measurements a had to assume the top half was already cut to size.
You will also notice the huge difference cowl to spinner spacing between the top and bottom halves.
Not a very well written thread, still a little frustrated. If you can make sense of this thread then please explain your installation sequence
http://i44.tinypic.com/1kx3q.jpg
Regards Peter
Last edited by a moderator: