RV-12 Trim setup Question

[Gerald Clabots]

Any 12 builder have the sensor position and values for setting up the trim indicator in the skyview EFIS.
If you could email or PM me.
If you have a screen shot would also work.
Thanks

Gerry

 

[KALEWIS]

The skyview sensor values may differ from plane plane to plane. Best advice is to follow the setup outlined in the Production Acceptance Procedures and skyview install / user manuals. I have been thru the calibration process for the trim a few times and got different (but similar) values each time.

 

[Bill_H]

See this:
http://www.vansairforce.com/community/showpost.php?p=736012&postcount=22

 

[Gerald Clabots]

RV-12 Trim Calibration

Could any 12 Skyview builder tell me what position on the sensor page that the trim tab is located. Looking at P23 on my skyview is a postion input, But the only selection available are flaps, aileron. rudder an elevator. When I operate the trim up or down the input numbers change so I think this is the correct input
When I go to hardware calibration the system does not allow me to access the trim calibration.
Any ideas?

 

[rvbuilder2002]

The antiservo tab is related to pitch (elevator) trim so in the calibration page you want to select elevator.

 

[Gerald Clabots]

Thanks Scott I'll try that tomorrow.
Gerry

 

[RFSchaller]

I have the D180, so this may or may not help. I timed the full travel and set my reference Mark at the half way point. I use a takeoff trim point slightly nose low to the mark.