Time to fit the bottom rudder fairing. Just sizing up the fairing prior to trimming and noticed the two halves have been bonded together with a noticeable twist. Perhaps 5 degrees or so, but it is quite obvious looking along the part. I happen to have a second fairing on the shelf and that has the same twist. On both fairings the bulge to mount the tail light is asymmetric also. That follows, I guess.
My question is, are they all like that and do other guys cut them apart and rebond them? Or do you just accept it and move on? Maybe send them back.
Seems like pretty sloppy work from Van's.
My question is, are they all like that and do other guys cut them apart and rebond them? Or do you just accept it and move on? Maybe send them back.
Seems like pretty sloppy work from Van's.