CubedRoot
Well Known Member
Hey all,
I am looking at the thousands of pre-punched holes in my new wing kit, and considering spending some money in time savings if possible.
I recall that reamers can be safely used to match drill any prepunched holes (like skins to skeleton) without the need to go back and deburr like we normally do when we use a #30/#40 standard drill bit.
Is this true? Can I simply get a reamer and use it on all these hundreds of pre-punched holes and save my wrists and time from the deburing process afterwards?
If so, are reamers sold in the normal #30 / #40 sizes? Any recommendations on which to get? There seems to be many different kinds.
Thanks!
I am looking at the thousands of pre-punched holes in my new wing kit, and considering spending some money in time savings if possible.
I recall that reamers can be safely used to match drill any prepunched holes (like skins to skeleton) without the need to go back and deburr like we normally do when we use a #30/#40 standard drill bit.
Is this true? Can I simply get a reamer and use it on all these hundreds of pre-punched holes and save my wrists and time from the deburing process afterwards?
If so, are reamers sold in the normal #30 / #40 sizes? Any recommendations on which to get? There seems to be many different kinds.
Thanks!