Push Mount Cable Ties

[TASEsq]

Has anyone ever successfully used these instead of adel clamps?

TY538MX Push Mount Cable Ties 198 x 4.8mm

www.domcar.com.au

Or for more flexibility something like this which can take a cable tie?

Please note:

151-01906

www.hellermanntyton.com

 

[dmn056]

Has anyone ever successfully used these instead of adel clamps?

TY538MX Push Mount Cable Ties 198 x 4.8mm

www.domcar.com.au

Or for more flexibility something like this which can take a cable tie?

Please note:

151-01906

www.hellermanntyton.com

I've used these in a few places, especially where there's not much room for a clamp:

TM Cable Tie Mount - Panduit

Learn about Panduit P100068 Cable Tie Mounts and other Cable & Wire Ties, Mounts & Straps. Contact Panduit today.

www.panduit.com

 

[BravoAlphaRomeo]

I would not be afraid to use as long as they could be inspected (replaced). And of course I wouldn’t use them firewall forward.

 

[Freemasm]

Has anyone ever successfully used these instead of adel clamps?

TY538MX Push Mount Cable Ties 198 x 4.8mm

www.domcar.com.au

Or for more flexibility something like this which can take a cable tie?

Please note:

151-01906

www.hellermanntyton.com

Still requires drilling amounting hole and the ones I'm familiar with still have some movement; thus, will probably require replacement at some point. Will the "standard" 3M cable tie mounts work? Hard to beat the price. I'm laying out some sub-floor and emp runs with these using the existing foam tape. Following the advice of others, once happy with the locations, I'll more permanently mount them with a dab of pro-seal or similar once everything finds its permanent home

Just an option if you're not already considering/applying such..

3M tie mounts, Amazon

 

[fl-mike]

Still requires drilling amounting hole and the ones I'm familiar with still have some movement; thus, will probably require replacement at some point. Will the "standard" 3M cable tie mounts work? Hard to beat the price. I'm laying out some sub-floor and emp runs with these using the existing foam tape. Following the advice of others, once happy with the locations, I'll more permanently mount them with a dab of pro-seal or similar once everything finds its permanent home

Just an option if you're not already considering/applying such..

3M tie mounts, Amazon

The 3M mounts will dry out or the foam will deteriorate and fall off, so only utilize if you use a better adhesive.

 

[Mikeyb]

These from HT are amazing. They use the 3m VHB adhesive. They aren’t coming off unless you take them off with a heat gun.

 

[TASEsq]

These from HT are amazing. They use the 3m VHB adhesive. They aren’t coming off unless you take them off with a heat gun.

I have used these in a couple of places where I couldn’t drill a hole - like on the spat and the aft window / roll bar brace.

 

[Ironflight]

These from HT are amazing. They use the 3m VHB adhesive. They aren’t coming off unless you take them off with a heat gun.

You can also buy the regular mounts, buy a roll of VHB tape (you should have that anyway!), peel the factory adhesive off the mounts and cut out a square of VHB… if you like to “DIY”….