justplanecrazy
Member
Probably a stupid question however I was installing the prop govenor cable in the shop last night and came across a problem that has caused me to start scratching my head where the rod end attaches to the govenor arm.
Installation diagrams show a AN3-11A bolt with several washers passing through the rod end, another washer, through the govenor arm, washer and then metal lock nut. The direction the bolt is to be installed is from the govenor side of the govenor arm however the bolt is too long to fit between the govenor and the arm. Is there a trick other than removing the govenor arm and then trying to reassemble with the correct spring tension?
Many thanks,
Rob
Installation diagrams show a AN3-11A bolt with several washers passing through the rod end, another washer, through the govenor arm, washer and then metal lock nut. The direction the bolt is to be installed is from the govenor side of the govenor arm however the bolt is too long to fit between the govenor and the arm. Is there a trick other than removing the govenor arm and then trying to reassemble with the correct spring tension?
Many thanks,
Rob