Looking for some help I went to reinstall my Hartzell 2 bladed prop this weekend and one of the retained attachment studs went in "hard" I ended up shearing the roll pin that holds the captured nut in place.
After getting the prop back off - I was able to get the stud out and saw some damage to the first 1/16 of an inch of thread. I chased with a 1/2 by 20 tap and wanted advice on leaving the bushing or replacing it.
Hopefully the photos come through, first time attempting to upload images to this page.
If it will help I will try to get a photo of the threads tonight.
Thanks
https://lh3.googleusercontent.com/3...sMEzOUIJux117HoSY7lpKNGqouCnLSBN=w640-h480-no
https://lh3.googleusercontent.com/c...ok5nNx9nknnq2-rT7_hJs5VG4rIimuss=w480-h640-no
https://lh3.googleusercontent.com/t...-gihP7Sia_dyk0WgBmu4Ysm0oO8dpAI0=w480-h640-no
`
After getting the prop back off - I was able to get the stud out and saw some damage to the first 1/16 of an inch of thread. I chased with a 1/2 by 20 tap and wanted advice on leaving the bushing or replacing it.
Hopefully the photos come through, first time attempting to upload images to this page.
If it will help I will try to get a photo of the threads tonight.
Thanks
https://lh3.googleusercontent.com/3...sMEzOUIJux117HoSY7lpKNGqouCnLSBN=w640-h480-no
https://lh3.googleusercontent.com/c...ok5nNx9nknnq2-rT7_hJs5VG4rIimuss=w480-h640-no
https://lh3.googleusercontent.com/t...-gihP7Sia_dyk0WgBmu4Ysm0oO8dpAI0=w480-h640-no
Last edited: