I am looking for any constructive comments on this panel layout prior to pulling to trigger and getting it cut. Items on the bubble right now are the panel mount Guardian CO monitor (I am looking at a remote unit that would interface with the EFIS), the HOBBS, and the storage compartment.
http://i1086.photobucket.com/albums/j448/JSBergen/Panellayout-1.jpg
Paul at Steinair did the layout.
Relative to the components:
Garmin G3x dual screen
PSxxxx audio panel
Garmin GTN650 (cut now add later)
Garmin SL40
Garmin 327 transponder
Trutrac Gx A/P
Also included are display and lean knob for Eagle EFI
Dynon D6 EFIS (backup)
Switch cut outs are for nkk paddle switches.
I am planning on the Verticle Power VPX-Pro for the electrical control
Dual alternator, single battery
Am I missing any critical items? Does the spacing look adiquate? Any thoughts would be appreciated.
Regards,
Jamie
http://i1086.photobucket.com/albums/j448/JSBergen/Panellayout-1.jpg
Paul at Steinair did the layout.
Relative to the components:
Garmin G3x dual screen
PSxxxx audio panel
Garmin GTN650 (cut now add later)
Garmin SL40
Garmin 327 transponder
Trutrac Gx A/P
Also included are display and lean knob for Eagle EFI
Dynon D6 EFIS (backup)
Switch cut outs are for nkk paddle switches.
I am planning on the Verticle Power VPX-Pro for the electrical control
Dual alternator, single battery
Am I missing any critical items? Does the spacing look adiquate? Any thoughts would be appreciated.
Regards,
Jamie