Page 11-03, Figure 4, "SECURING THE ELEVATOR HORN"

[etocr]

Hey Gang,

Help! I'm at a complete loss on how to insert the washers highlighted below.

I tried using small strips of tape to "slide" the washers into place however with no success.

Any techniques are appreciated!

 

[bertschb]

I used these in multiple places in my build:

Washer Wrench Set | Aircraft Spruce ®

Washer Wrench Set Washer Wrench Set. This is a (4) piece washer wrench set. It's used to hold AN/aircraft washers to reach into hard to reach areas.

www.aircraftspruce.com

 

[Mel]

I used these in multiple places in my build:

Washer Wrench Set | Aircraft Spruce ®

Washer Wrench Set Washer Wrench Set. This is a (4) piece washer wrench set. It's used to hold AN/aircraft washers to reach into hard to reach areas.

www.aircraftspruce.com

These are extremely handy!

 

[Z32MadMan]

I find a small telescoping magnet stick is useful in those situations. A pick or bent safety wire can also be used through the hole bolt hole to 'capture' the washer once it's in position.

 

[WayneJ]

I usually use the Washer Wrenches noted above. But this works too.