snoopyflys
Well Known Member
Hi all,
Been skipping along with my FWF build installing my NPT fluid fittings using Fuel Lube ( a.k.a. EZ Turn) and recently discovered in a few postings and in Section 5 of my build manual to not use Fuel lube with NPT fittings
So, should I remove all of the NPT fittings and clean them using some sort of solvent or leave it be a see what leaks then address it? Not sure what will clean Fuel lube enough to allow Permatex #2 to do its job. Any words of wisdom would be appreciated for my dumb use of sealants.
Thanks
Been skipping along with my FWF build installing my NPT fluid fittings using Fuel Lube ( a.k.a. EZ Turn) and recently discovered in a few postings and in Section 5 of my build manual to not use Fuel lube with NPT fittings
So, should I remove all of the NPT fittings and clean them using some sort of solvent or leave it be a see what leaks then address it? Not sure what will clean Fuel lube enough to allow Permatex #2 to do its job. Any words of wisdom would be appreciated for my dumb use of sealants.
Thanks