DonFromTX
Well Known Member
I have always tried to screw up if a different way, not the boring ways that are not too exciting.
I could use some ideas on this one. While looking up the channel where the main landing gear fits, I noticed I had missed some rivets! The missing are where the floor ribs rivet to the channel, for some reason I missed them. I was able with several rivet squeezers thru the end and up thru the inspection holes in the bottom to get some of them in, but there are a few missing and no way to install them.
I finally decided the BEST way was to cut the seat floor along the sharpie dotted lines in the photo, then rivet the pieces back in. Anybody else done this? Anybody have any better ideas?
[/IMG]
I could use some ideas on this one. While looking up the channel where the main landing gear fits, I noticed I had missed some rivets! The missing are where the floor ribs rivet to the channel, for some reason I missed them. I was able with several rivet squeezers thru the end and up thru the inspection holes in the bottom to get some of them in, but there are a few missing and no way to install them.
I finally decided the BEST way was to cut the seat floor along the sharpie dotted lines in the photo, then rivet the pieces back in. Anybody else done this? Anybody have any better ideas?