DragonflyAero
Well Known Member
I am not sure what I need to hook up my prop control on my -7. I am using a center quadrant and have a PCU5000X governor. I rotated the governor control so it points up. The control cable exit is toward the left side of the firewall. I tried using ACS A-960 cable with an Aurora bearing end fitted on the 1/4-24 threaded end. The other end of the cable I used a wire grip with 10-32 threads and a clevis to attach to the quadrant arm.
The cable has to make a very tight turn as it exits the firewall on the engine side to bend over the the governor. I thought the solution would be to use a smaller diameter Bowden but all I see listed at ACS is .078 wire.
Can anyone offer advice on how you did this?
The cable has to make a very tight turn as it exits the firewall on the engine side to bend over the the governor. I thought the solution would be to use a smaller diameter Bowden but all I see listed at ACS is .078 wire.
Can anyone offer advice on how you did this?
Last edited: