kentb
Well Known Member
RV9A - tipup. I have had the skin on before, when I fitted the top cowl. I had the hinge and shim in place and drilled and clecoed the whole thing.
Now I am doing finial fitting of the cowl and so clecoed the skin back on. The only differance now is that the hinge has been counter sunk and the shim and skin was dimpled. I can't get both sides of the in the front to line up enough to cleco. I have install my cowl and the hinge pins were very difficult to insert.
Any suggestions?
If I start riveting from the top center and work out in both directions will the holes line back up?
Kent
almost there.
Now I am doing finial fitting of the cowl and so clecoed the skin back on. The only differance now is that the hinge has been counter sunk and the shim and skin was dimpled. I can't get both sides of the in the front to line up enough to cleco. I have install my cowl and the hinge pins were very difficult to insert.
Any suggestions?
If I start riveting from the top center and work out in both directions will the holes line back up?
Kent
almost there.