I moved my 9A from CID to ABQ. Easy. Get the proper Penske truck (the rear door is just barely wide enough to squish the main gear thru), build a pair of long wooden ramps. Put the wings in a cradle, and buy Harbor Freight out of ratchet straps.
Also rent 5 dozen moving blankets or more. I was able to keep them for almost nothing!
Plenty of room for fuselage on gear, wings in a cart, and all sorts of tools, etc.
Use tons of padding and straps
See if this link works:
https://goo.gl/photos/bzbQRpYWiChoxbGz7
It was either the 26' (see link below) truck. I only wanted the 22' but there were none available. The width is the key dimension and it is the same. It is a diesel truck, so prepare for about 5mpgDave. What size truck did you end up getting? 20' or 26'?
Moving aircraft projects...it's what they do. They moved my QB wings and fuse from OR to Langley AFB VA, then moved my mostly-completed project to 52F here in the DFW area. Their truck trailers are low-floored and outfitted for safely hauling our portioned aircraft, and they're insured (are you in your Penske?).
Between Partain and a rental van (lease, gas, time, etc), the cost is about the same but the aircraft gets better care IMO.