Not wanting to ruin these, I seek advice.
Measuring from the #2 hole down 1 7/8” for the top of the cutout, then up from the #3 hole 1 3/4”, I should theoretically find the cutout to be the necessary 1 1/32” width. I do not…. It’s short by ~3/32
My distance from #2 to #3 hole is 4.5” where it should be 4.65” if I add the distances from dwg 36-04
From your experience, which way should I adjust the cutout or will it not matter?
Thanks!
Measuring from the #2 hole down 1 7/8” for the top of the cutout, then up from the #3 hole 1 3/4”, I should theoretically find the cutout to be the necessary 1 1/32” width. I do not…. It’s short by ~3/32
My distance from #2 to #3 hole is 4.5” where it should be 4.65” if I add the distances from dwg 36-04
From your experience, which way should I adjust the cutout or will it not matter?
Thanks!
