Hello all!
What type of fitting does the manifold pressure tap on an 0-320 require at the cylinder head? Is it the same as a primer tap? ANxxxx?
I was performing some MX when I noticed the manifold pressure line had completely severed at the tap that screws into the cylinder head (#4 in my instance). There is currently a solid line from the panel into the engine bay; it stops short ~6" which then went to a flexible hose. The flex hose was attached to the hard line with a standard automotive screw type hose clamp that continued to the cylinder tap. Mine looks to either be crimped around the flexible hose but it could very well be a 'factory' fitting.
I think I'm just not using the right search terms! I edited the thread cause I think I'm on the right track with just needing to know the correct ANxxx fitting.
Thanks!
What type of fitting does the manifold pressure tap on an 0-320 require at the cylinder head? Is it the same as a primer tap? ANxxxx?
I was performing some MX when I noticed the manifold pressure line had completely severed at the tap that screws into the cylinder head (#4 in my instance). There is currently a solid line from the panel into the engine bay; it stops short ~6" which then went to a flexible hose. The flex hose was attached to the hard line with a standard automotive screw type hose clamp that continued to the cylinder tap. Mine looks to either be crimped around the flexible hose but it could very well be a 'factory' fitting.
I think I'm just not using the right search terms! I edited the thread cause I think I'm on the right track with just needing to know the correct ANxxx fitting.
Thanks!
Last edited: