Marshall@SkyDynamics
I'm New Here
Hi all, Klaus is out of the office for a bit so I'm trying find this answer elsewhere.
We're finishing up a Lyc. TIO-540 engine which is on the dyno now. Using a LightSpeed plasma 3 system. Looking at the wiring schematic there should be a tach signal coming out of the input harnesses...our input harnesses only go to the position sensor and +12v/gnd. See picture below...
Is it standard to have to solder in the tach output wire? We have the displays as well, but our data acquisition will deal with an rpm pulse better than analog 0-0.3v. So splicing into the display's harness would be a last resort.
Thanks in advance,
Marshall
We're finishing up a Lyc. TIO-540 engine which is on the dyno now. Using a LightSpeed plasma 3 system. Looking at the wiring schematic there should be a tach signal coming out of the input harnesses...our input harnesses only go to the position sensor and +12v/gnd. See picture below...
Is it standard to have to solder in the tach output wire? We have the displays as well, but our data acquisition will deal with an rpm pulse better than analog 0-0.3v. So splicing into the display's harness would be a last resort.
Thanks in advance,
Marshall
Last edited: