HAL Pilot
Well Known Member
Aloha All
On Page 06-04 Fig 2 there is a note to leave a hole open on VS-410PP
I can not find that this hole is used anywhere later. So two questions.
Is this hole used later?
If not, then does it matter if this hole is countersunk and dimpled as it says in step 5? I'm leaning towards not doing anything with it and leave as is.
On Page 06-04 Fig 2 there is a note to leave a hole open on VS-410PP
I can not find that this hole is used anywhere later. So two questions.
Is this hole used later?
If not, then does it matter if this hole is countersunk and dimpled as it says in step 5? I'm leaning towards not doing anything with it and leave as is.