Dean Pichon
Well Known Member
Mattituck installed a set PMags in my engine and ran it in the test cell. I assume they did so without using the jumper described in the installation manual as no jumper was present on the mags when I received the engine.
I am reluctant to do anything to change what Mattituck assembled/tested, but notice the PMag installation manual suggests using the jumper.
Can anyone provide some addtional info to help me make the decision regarding whether or not to install the jumper at this point. E.g. Why is the jumper recommended? Would Mattituck have reason to run without the jumper, or did they likely remove it?
Thanks,
I am reluctant to do anything to change what Mattituck assembled/tested, but notice the PMag installation manual suggests using the jumper.
Can anyone provide some addtional info to help me make the decision regarding whether or not to install the jumper at this point. E.g. Why is the jumper recommended? Would Mattituck have reason to run without the jumper, or did they likely remove it?
Thanks,