Ivan Kristensen
Well Known Member
I just received these ignition wire clips from Geoff Combs at Aerosport Modelling https://www.aerosportproducts.com/ He just added these to a long list of RV products produced by his company. Kudos to Geoff for adding this top quality and useful product to an already great lineup.
They are available for two wires or for three. Two ways of fastening, an #10 CS bolt or a 3/16" zip tie.
I didn't have a proper length CS bolt so I just used AN3 bolt with a washer on the stand off. The one to the right is just clipped in place without being fasten down, this really stiffens up the longer wire run.
Here I am using a 3 wire clip but because I needed to secure only two wires I used the third clip for a MAP hose.
They are available for two wires or for three. Two ways of fastening, an #10 CS bolt or a 3/16" zip tie.
I didn't have a proper length CS bolt so I just used AN3 bolt with a washer on the stand off. The one to the right is just clipped in place without being fasten down, this really stiffens up the longer wire run.
Here I am using a 3 wire clip but because I needed to secure only two wires I used the third clip for a MAP hose.