KCBerner
Well Known Member
I'm 99% sure this part is trash but thought I'd put it out here to see if anyone has any thoughts. I was dimpling leading edge skin tonight and the skin slipped off of the dimple die. Before I knew about it, I had made this new hole
Of course the new hole had some cracks so I tried drilling/reaming it out. I got to a #30 and it will need to go larger to get rid of the cracks.
Worst part to me is that it is under the rib flange so there's no convenient way to fabricate a patch panel
So, assuming that I would have to ream this out to a #19 at least to clean up the cracks, any great ideas or am I just calling Vans tomorrow for my first over $100 mistake?
Of course the new hole had some cracks so I tried drilling/reaming it out. I got to a #30 and it will need to go larger to get rid of the cracks.
Worst part to me is that it is under the rib flange so there's no convenient way to fabricate a patch panel
So, assuming that I would have to ream this out to a #19 at least to clean up the cracks, any great ideas or am I just calling Vans tomorrow for my first over $100 mistake?