Hi gang: I’m trying to wire a set of headphone receptacles to an old Garmin GNC 250. I wired the receptacles in parallel together and have a shielded three conductor wiring running to the radio. At the time I thought I used a diagram from Stien to wire the receptacles, but now I’m not sure.
I have the white wire going to the tip of microphone receptacle (small hole).
I have the orange wire going to the ring (middle section of plug) of the headphone receptacle (large hole)
I have the blue wire going to the barrel of headphone receptacle.
I have the Orange wire connected to pin #2 (mic audio Hi)
I have blue wire connected to #3 pin (mic audio Lo)
I have white wire connected to pin #5 (Comm audio Hi)
I have the shielded braid going to #25 pin (ground)
It’s not working and I’m struggling to figure it out.
First does someone have a diagram for wiring up the receptacles if I don’t have it correct?
Secondly can someone help me with the pins I should be using on the radio? The installation manual I have for the radio is not much help in this regard.
The push to talk is coming from the top of the stick and that is working.
Thanks in advance, Terry



I have the white wire going to the tip of microphone receptacle (small hole).
I have the orange wire going to the ring (middle section of plug) of the headphone receptacle (large hole)
I have the blue wire going to the barrel of headphone receptacle.
I have the Orange wire connected to pin #2 (mic audio Hi)
I have blue wire connected to #3 pin (mic audio Lo)
I have white wire connected to pin #5 (Comm audio Hi)
I have the shielded braid going to #25 pin (ground)
It’s not working and I’m struggling to figure it out.
First does someone have a diagram for wiring up the receptacles if I don’t have it correct?
Secondly can someone help me with the pins I should be using on the radio? The installation manual I have for the radio is not much help in this regard.
The push to talk is coming from the top of the stick and that is working.
Thanks in advance, Terry



