Today I went out and installed the windows into the doors as well as the rear windows and the windshield (Minus all the glass work).
I used Lord Adhesive and it all turned out fairly well. There only 1 spot on the rear left window that is about 1/16th higher than the cabin top. I'll sand that edge to blend it before glassing the seams. Which then occurred to me I may or may not know what I'm doing when it comes to that.
Next to glass in the seams is it just a single layer of about 1" wide fiberglass around the entire perimeter? I have 3/4" of the edge of the windows taped out and roughed up so that would leave an over hang over around 1/4" that I would blend into the cabin top.
After the seams tape is cured would I then just plan on micro'ing everything as I finish up the cabin top exterior?
Thanks in advance!
I used Lord Adhesive and it all turned out fairly well. There only 1 spot on the rear left window that is about 1/16th higher than the cabin top. I'll sand that edge to blend it before glassing the seams. Which then occurred to me I may or may not know what I'm doing when it comes to that.
Next to glass in the seams is it just a single layer of about 1" wide fiberglass around the entire perimeter? I have 3/4" of the edge of the windows taped out and roughed up so that would leave an over hang over around 1/4" that I would blend into the cabin top.
After the seams tape is cured would I then just plan on micro'ing everything as I finish up the cabin top exterior?
Thanks in advance!
Last edited: