newimaging
Active Member
I have my outboard leading edge and my tank leading edge clecoed on the spar, but have a small hight difference at the very tip of the leading edges.
Basically I have trouble pulling the skin tight enough over the outboard closing rib of the wing-tank, therefor it sits about 1mm higher.
How do you guys get the rib in tight will riveting it, especially when you add a bunch of pro-seal in between. You use ratchet straps, a rubber mullet, ..??
Question #2
Can I drill the tank mounting holes to the W-423 connector plate for the platenuts after riveting the tank and outboard leading edges. It seem like I would have more control of getting the edges to meet.
Christian
Basically I have trouble pulling the skin tight enough over the outboard closing rib of the wing-tank, therefor it sits about 1mm higher.
How do you guys get the rib in tight will riveting it, especially when you add a bunch of pro-seal in between. You use ratchet straps, a rubber mullet, ..??
Question #2
Can I drill the tank mounting holes to the W-423 connector plate for the platenuts after riveting the tank and outboard leading edges. It seem like I would have more control of getting the edges to meet.
Christian