BruceMe
Well Known Member
Per the manual I wired my stock RV resistive fuel sensors on my GAE 24 as P244 pins 6 & 9 shielded.
There is a perceivable ramp .8v-2.1v (empty-full), but it's very small and very noisy especially < 7g it's just bouncing around virtually unreadable.
Should this be pulled up or conditioned?
Thanks,
-Bruce
There is a perceivable ramp .8v-2.1v (empty-full), but it's very small and very noisy especially < 7g it's just bouncing around virtually unreadable.
Should this be pulled up or conditioned?
Thanks,
-Bruce